| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Průša, Filip
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (8/8 displayed)
- 2022Microstructure and Mechanical Properties of Ti-25Nb-4Ta-8Sn Alloy Prepared by Spark Plasma Sinteringcitations
- 2022Corrosion Properties of Boron- and Manganese-Alloyed Stainless Steels as a Material for the Bipolar Plates of PEM Fuel Cellscitations
- 2021The effect of powder size on the mechanical and corrosion properties and the ignition temperature of WE43 alloy prepared by spark plasma sinteringcitations
- 2021Dense ceramics of lanthanide-doped Lu2O3 prepared by spark plasma sinteringcitations
- 2021Influence of Ceramic Particles Character on Resulted Properties of Zinc-Hydroxyapatite/Monetite Compositescitations
- 2021Specific interface prepared by the SPS of chemically treated Mg-based powdercitations
- 2021Indentation Size Effect in CoCrFeMnNi HEA Prepared by Various Techniquescitations
- 2020Characterization of a Zn‐Ca5(PO4)3(OH) composite with a high content of the hydroxyapatite particles prepared by the spark plasma sintering processcitations
Places of action
| Organizations | Location | People |
|---|
article
Specific interface prepared by the SPS of chemically treated Mg-based powder
Abstract
This work focuses on a new way of preparation of magnesium-based composite materials by powder metallurgy. This method consists of combination of chemical treatment of magnesium powder in hydrofluoric acid and subsequent compaction by spark plasma sintering. As a result a continuous network of magnesium fluoride coating is created inside material. However, magnesium alloys behave differently in hydrofluoric acid. In the case of WE43 alloy a network consisting of magnesium fluoride and newly emerged yttrium fluoride is prepared. This specific interface of the prepared composite material resulted in a corrosion rate that was three times lower compared to that of the sample sintered without chemical treatment. The cause of improvement of corrosion properties is illustratively shown on the cuts of the samples after immersion. The corrosion front is slowed down on the fluoride interface. The presence of yttrium fluoride phases on the interface slightly reduced mechanical properties. © 2020 Elsevier B.V.