| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Pavlik, Zbysek
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (43/43 displayed)
- 2021The influence of graphene specific surface on material properties of MOC-based composites for construction usecitations
- 2020Interior thermal insulation systems based on wood fiberboards: experimental analysis and computational assessment of hygrothermal and energy performance in the Central European climatecitations
- 2020Magnesium Oxybromides MOB-318 and MOB-518: Brominated Analogues of Magnesium Oxychloridescitations
- 2020Low-Carbon Composite Based on MOC, Silica Sand and Ground Porcelain Insulator Wastecitations
- 2019PROPERTIES OF HIGH-PERFORMANCE FIBER-REINFORCED CONCRETE AFTER THERMAL TREATMENT AT HIGH TEMPERATUREScitations
- 2018Fabrication of Dodecanol/Diatomite Shape-Stabilized PCM and Its Utilization in Interior Plastercitations
- 2018EVALUATION OF HYGRIC PROPERTIES OF CONTEMPORARY PLASTERS
- 2018Blended Cements with Calcined Illitic Clay: Workability and Hydrationcitations
- 2018Thermal and hygric assessment of an inside-insulated brick wall: 2D critical experiment and computational analysiscitations
- 2018Microclimate of a Former Treasury in Cathedral of Assumption of Our Lady and Saint John the Baptist in Sedlec - Long-Time Analysiscitations
- 2018Long-Time Assessment of Hygrothermal Conditions of the Sedlec Charnel Housecitations
- 2018Biomass ash-based mineral admixture prepared from municipal sewage sludge and its application in cement compositescitations
- 2018Complex assessment of reconstruction works on an institutional building: A case studycitations
- 2018Structural, mechanical and hygrothermal properties of lightweight concrete based on the application of waste plasticscitations
- 2018Physical and chemical characterization of technogenic pozzolans for the application in blended cementscitations
- 2017Effect of cement composition on the early hydration of blended cements with natural zeolitecitations
- 2017Application of Infrared Thermography in Complex Moisture Inspection of the Schebek Palacecitations
- 2017EFFECT OF THE MODE AND DYNAMICS OF THERMAL PROCESSES ON DSC-ACQUIRED PHASE-CHANGE TEMPERATURE AND LATENT HEAT OF DIFFERENT KINDS OF PCMcitations
- 2017Chapel of Cemetery Church of All Saints in Sedlec - Long-Term Analysis of Hygrothermal Conditionscitations
- 2017Simultaneous Thermal Analysis and Thermodilatometry of Hybrid Fiber Reinforced UHPCcitations
- 2017EVALUATION OF THE APPLICATION OF A THERMAL INSULATION SYSTEM: IN-SITU COMPARISON OF SEASONAL AND DAILY CLIMATIC FLUCTUATIONS
- 2017Moisture Diffusivity of HPFRC Exposed to High Temperatures
- 2017Effect of Silica Fume on Hydration of Air-Cured Blended Cement Pastes Measured by DSC/TG Analysiscitations
- 2015Effect of Sandstone Anisotropy on its Heat and Moisture Transport Propertiescitations
- 2015Effective Heat and Moisture Transport Parameters of Stone Masonry
- 2015Laboratory Testing of a Newly Developed Brick Based Building Envelope in the Difference Climate Conditions
- 2015Moisture Dependent Thermal Properties of Hydrophilic Mineral Wool: Application of the Effective Media Theorycitations
- 2014Effective thermal conductivity of hollow bricks with cavities filled by air and expanded polystyrenecitations
- 2014Hygrothermal Performance of Sandstone Historical Masonry under Different Climatic Conditions
- 2014Mechanical, hygric, and durability properties of cement mortar with MSWI bottom ash as partial silica sand replacement
- 2014Effect of temperature on water vapor transport propertiescitations
- 2014Utilization of ceramic wastes as replacement of portland cementscitations
- 2012Identification of Water Vapour Transport Properties of Gypsum Using Evolutionary Algorithmscitations
- 2011Simultaneous monitoring of moisture and salt concentration using the time domain reflectrometry method
- 2011A Transient Analysis of Water Vapor Transport in Porous Materials in Dependence on Relative Humidity
- 2011Computational and experimental analysis of heat and moisture transport in a critical detail of a contact thermal insulation system
- 2011Application of the Domain Reflectometry in Identification of Moisture Transport Parameters of Building Materials
- 2010EFFECT OF METAKAOLIN ADDITION ON THE MOISTURE AND CHLORIDE TRANSPORT AND STORAGE PROPERTIES OF HIGH PERFORMANCE CONCRETE
- 2010Municipal solid waste incineration ashes and their potential for partial replacement of Portland cement and fine aggregates in concrete
- 2010Accurate determination of moisture content: a necessary condition for thermal assessment of multi-layered systems of porous materials
- 2008Determination of Moisture Content of Hygroscopic Building Materials Using Time Domain Reflectometrycitations
- 2007Application of Time-domain Reflectometry Method for Measuring Moisture Content in Porous Building Materialscitations
- 2006Determination of moisture diffusivity using the time domain reflectometry (TDR) methodcitations
Places of action
| Organizations | Location | People |
|---|
article
The influence of graphene specific surface on material properties of MOC-based composites for construction use
Abstract
In this study, the influence of the graphene specific surface area used as a dopant in magnesium oxychloride cement (MOC) was researched. This composite was developed in order to form a suitable high-performance material which would act as an alternative for the commonly used Portland cement. It presents as highly ecofriendly, while maintaining great mechanical properties, which evolve due to the use of small amount of graphene nanoplatelets. Three sets of samples, which were prepared (one reference and two composite samples with graphene with different particle size/surface area) were subjected to a broad spectrum of analyses in order to study the differences in the chemical, mechanical and microstructural properties of the composites. Among the used analytical methods, the optical microscopy, scanning electron microscopy, transmission electron microscopy, X-ray diffraction, energy dispersive spectroscopy, Fourier-transform infrared spectroscopy and various mechanical, microstructural and macrostructural tests were performed. The obtained results show mainly the influence of the graphene nanoplatelets' specific surface on the mechanical, chemical and physical properties, including large increase in the compressive and flexural strength and a significant drop of the total porosity of such material. These results might be helpful in the development of the MOC-graphene composite with improved mechanical performance and durability, and can contribute to the field of graphene-doped construction materials, which are being thoroughly studied in the past years.