693.932 PEOPLE
| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Huang, Yuanding
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (23/23 displayed)
- 2022Effects of Y Additions on the Microstructures and Mechanical Behaviours of as Cast Mg–<i>x</i>Y–0.5Zr Alloyscitations
- 2022Revisiting the tolerance limit of Fe impurity in biodegradable magnesiumcitations
- 2022Electrical Resistivity of Binary Mg Alloys
- 2022Effects of Y Additions on the Microstructures and Mechanical Behaviours of as Cast Mg–xY–0.5Zr Alloyscitations
- 2021Influence of the amount of intermetallics on the degradation of Mg-Nd alloys under physiological conditionscitations
- 2020Effects of Intermetallic Microstructure on Degradation of Mg-5Nd Alloycitations
- 2015Mechanical properties and corrosion behavior of Mg-Gd-Ca-Zr alloys for medical applicationscitations
- 2014Experimental and numerical analysis of hot tearing susceptibility for Mg–Y alloyscitations
- 2013Element distribution in the corrosion layer and cytotoxicity of alloy Mg-10Dy during in vitro biodegradationcitations
- 2013Compression-creep response of magnesium alloy DieMag422 containing barium compared with the commercial creep-resistant alloys AE42 and MRI230Dcitations
- 2013Hot tearing susceptibility of binary Mg-Y alloy castingscitations
- 2013Hot Tearing Characteristics of Binary Mg-Gd Alloy Castingscitations
- 2012Hot Tearing Susceptibility of Magnesium-Gadolinium Binary Alloyscitations
- 2012Influence of ageing treatment on microstructure, mechanical and bio-corrosion properties of Mg–Dy alloyscitations
- 2011Mechanism of grain refinement of Mg-Al alloys by SiC inoculationcitations
- 2011Mechanical and corrosion properties of binary Mg-Dy alloys for medical applicationscitations
- 2010Approaching bolt load retention behaviour of AS41 through compliance and creep deformation
- 2009Quantitative determination on hot tearing in Mg-Al binary alloyscitations
- 2009Investigations on hot tearing of Mg-Al binary alloys by using a new quantitative method
- 2008Effects of segregation of primary alloying elements on the creep response in magnesium alloyscitations
- 2007Effect of microstructural inhomogeneity on creep response of Mg-Sn alloyscitations
- 2007Microstructural investigations of Mg-Al alloys containing small amount of sic nucleants
- 2006Effects of interfacial reactions during solidification on mechanical properties in short fiber reinforced AlSi12CuMgNi composites
Places of action
| Organizations | Location | People |
|---|
article
Influence of ageing treatment on microstructure, mechanical and bio-corrosion properties of Mg–Dy alloys
Abstract
Mg–Dy alloys have shown to be promising for medical applications. In order to investigate the influence of ageing treatment on their mechanical and corrosion properties, three Mg–xDy alloys (x=10, 15, 20 wt%) were prepared. Their microstructure, mechanical and corrosion behavior were investigated. The results indicate that ageing at 250 °C has little influence on the mechanical and corrosion properties. In contrast, ageing at 200 °C significantly increases the yield strength, and reduces the ductility. After ageing at 200 °C, the corrosion rate of Mg–20Dy alloy increases largely in 0.9 wt% NaCl solution, but remains unchanged in cell culture medium.