| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Green, Nicholas
University of Birmingham
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (11/11 displayed)
- 2013Complex free surface flows in centrifugal casting : computational modelling and validation experimentscitations
- 2013Modelling and validation : casting of Al and TiAl alloys in gravity and centrifugal casting processescitations
- 2012In situ characterisation of entrainment defects in liquid Al-Si-Mg alloy
- 2012Modeling of centrifugal casting processes with complex geometries
- 2011Modelling centrifugal casting: the challenges and validation
- 2010Centrifugal casting of complex geometries
- 2010An investigation on DC casting of a wrought aluminium alloy at below liquidus temperature by using melt conditionercitations
- 2009Centrifugal casting of complex geometries: Computational modelling and validation experiments
- 2009Complex free surface flows for mould filling using centrifugal casting
- 2008Surface segregation during directional solidification of Ni-base superalloyscitations
- 2001Influence of casting technique and hot isostatic pressing on the fatigue of a Al-7Si-Mg alloycitations
Places of action
| Organizations | Location | People |
|---|
article
An investigation on DC casting of a wrought aluminium alloy at below liquidus temperature by using melt conditioner
Abstract
The application of Melt Conditioner (MC) for production of high-quality DC billets and slabs at semisolid state is examined. In this technique, liquid metal is continuously fed into a twin-screw melt conditioning device, where the liquid metal or semisolid slurry is subjected to high shear rate, and then delivered continuously into a DC caster. In this paper, the feasibility of MCDC of a wrought aluminium alloy in the semi solid state has been investigated and the possibility of DC casting by MC technique below the liquidus temperature as a novel idea was explored. This idea may challenge the conventional DC casting which is normally performed above liquidus temperature. (C) 2010 Elsevier B.V. All rights reserved.