| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Pasanen, Toni P.
Helsinki Institute of Physics
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (21/21 displayed)
- 2023Surface passivation of Germanium with ALD Al2O3: Impact of Composition and Crystallinity of GeOx Interlayercitations
- 2023Excellent Responsivity and Low Dark Current Obtained with Metal-Assisted Chemical Etched Si Photodiodecitations
- 2023Comparison of SiNx-based Surface Passivation Between Germanium and Siliconcitations
- 2023Plasma-enhanced atomic layer deposited SiO2 enables positive thin film charge and surface recombination velocity of 1.3 cm/s on germaniumcitations
- 2023Quantifying the Impact of Al Deposition Method on Underlying Al2O3/Si Interface Qualitycitations
- 2022Perspectives on Black Silicon in Semiconductor Manufacturing: Experimental Comparison of Plasma Etching, MACE and Fs-Laser Etchingcitations
- 2022Millisecond-Level Minority Carrier Lifetime in Femtosecond Laser-Textured Black Siliconcitations
- 2022(oral talk) Compatibility of Al-neal in processing of Si devices with Al2O3 layer
- 2022Impact of doping and silicon substrate resistivity on the blistering of atomic-layer-deposited aluminium oxidecitations
- 2021Efficient photon capture on germanium surfaces using industrially feasible nanostructure formationcitations
- 2021Al-neal Degrades Al2O3 Passivation of Silicon Surfacecitations
- 2020Modeling Field-effect in Black Silicon and its Impact on Device Performancecitations
- 2020Passivation of Detector-Grade Float Zone Silicon with Atomic Layer Deposited Aluminum Oxidecitations
- 2020Impact of doping and silicon substrate resistivity on the blistering of atomic-layer-deposited aluminium oxidecitations
- 2019Effect of MACE Parameters on Electrical and Optical Properties of ALD Passivated Black Siliconcitations
- 2019Compatibility of 3-D Printed Devices in Cleanroom Environments for Semiconductor Processingcitations
- 2019Compatibility of 3-D Printed Devices in Cleanroom Environments for Semiconductor Processingcitations
- 2019Passivation of Detector‐Grade FZ‐Si with ALD‐Grown Aluminium Oxidecitations
- 2018Economic Advantages of Dry-Etched Black Silicon in Passivated Emitter Rear Cell (PERC) Photovoltaic Manufacturingcitations
- 2018Economic Advantages of Dry-Etched Black Silicon in Passivated Emitter Rear Cell (PERC) Photovoltaic Manufacturingcitations
- 2017Surface passivation of black silicon phosphorus emitters with atomic layer deposited SiO2/Al2O3 stackscitations
Places of action
| Organizations | Location | People |
|---|
article
Impact of doping and silicon substrate resistivity on the blistering of atomic-layer-deposited aluminium oxide
Abstract
Aluminium oxide (Al2O3) thin films grown at low temperatures using atomic layer deposition (ALD) are known to often suffer from local delamination sites, referred to as “blisters”, after post-deposition annealing during device processing. In this work, we report our observation that doping of the silicon substrate has an effect on blister formation. The introduction of a highly doped layer by diffusion or implantation is found to significantly reduce blistering, compared to the non-doped regions in the immediate vicinity. Similar behavior is observed for both phosphorus and boron doping. Further investigation of this phenomenon using substrates with different resistivities reveals that even when introduced already during silicon crystal growth, doping affects the blistering of aluminium oxide films. Changes in several properties of silicon affected by doping, most importantly surface terminating groups, native oxide growth, and passivation of defects with hydrogen, are discussed as potential reasons behind the observed effect on blistering. ; Peer reviewed