| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Cieślak, Grzegorz
Institute of Precision Mechanics
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (16/16 displayed)
- 2024Enhanced mechanical properties and microstructural stability of ultrafine-grained biodegradable Zn-Li-Mn-Mg-Cu alloys produced by rapid solifictaion and high-pressure torsioncitations
- 2024Enhanced mechanical properties and microstructural stability of ultrafine-grained biodegradable Zn–Li–Mn–Mg–Cu alloys produced by rapid solidification and high-pressure torsioncitations
- 2023Properties of Ni-B/B Composite Coatings Produced by Chemical Reductioncitations
- 2021Evaluation of Harmonic Structure Obtained in Mechanically Milled Powders and Pulse Plasma Sintered Compacts of Austenitic Steelcitations
- 2020Influence of heat treatment on properties of Ni-B/B composite coatingscitations
- 2019The influence of volume fraction of amorphous phase on corrosion resistance of Mg67Zn29Ca4alloycitations
- 2019Structure and mechanical properties of nanocrystalline Ni/Cu multilayer coatings produced by the electrocrystallization methodcitations
- 2019The impact of different volume fractions of crystalline structures on the electrochemical behaviour of Mg67Zn29Ca4alloys for biomedical applicationscitations
- 2019Demystifying the sluggish diffusion effect in high entropy alloyscitations
- 2019Glass forming ability of Zr48Cu36Al16-xAgx alloys determined by three different methodscitations
- 2018Preparation and properties of nanocrystalline Ni/graphene composite coatings deposited by electrochemical methodcitations
- 2018Studies of “sluggish diffusion” effect in Co-Cr-Fe-Mn-Ni, Co-Cr-Fe-Ni and Co-Fe-Mn-Ni high entropy alloys; determination of tracer diffusivities by combinatorial approachcitations
- 2018Effect of structure on corrosion resistance of Mg-Zn-Ca alloy
- 2017Influence of Cu content on high temperature oxidation behavior of AlCoCrCuxFeNi high entropy alloys (x = 0; 0.5; 1)citations
- 2017Abrasion resistance of Ni-B/Si3N4 composite layers produced by electroless methodcitations
- 2016Preparation and mechanical properties of alumina composites reinforced with nickel-coated graphenecitations
Places of action
| Organizations | Location | People |
|---|
article
The influence of volume fraction of amorphous phase on corrosion resistance of Mg67Zn29Ca4alloy
Abstract
The aim of this study was to investigate the structure and corrosion resistance of amorphous, amorphous‐crystalline, and crystalline Mg67Zn29Ca4 alloy for biodegradable applications. This paper presents a preparation method and results of the structural characterization and corrosion resistance analysis of the material. Samples were prepared in the form of 3mm diameter rods. The structure of the alloy was examined with the use of X‐ray diffractometry and scanning electron microscopy. The thermal properties of the samples were examined with differential scanning calorimetry (DSC). Results of DSC analysis were used to determine heat treatment temperatures, allowing to obtain different fractures of crystalline phase in the material. Corrosion resistance of heat‐treated samples was investigated by immersion tests and electrochemical measurements performed in the simulated body fluid. The X‐ray diffraction results confirmed that the prepared Mg67Zn29Ca4 alloy’s structure is fully amorphous. After heat treatment, samples with different fractions of amorphous phase in the structure were obtained. Immersion tests of the samples showed that the structure significantly influenced corrosion resistance in examined materials. It should be pointed out, that certain amounts of crystalline phase in amorphous matrix can greatly improve the corrosion resistance of Mg67Zn29Ca4 alloy.