• Grünleitner, Theresa
• Bissolo, Michele
• Henning, Alexander
• Rieger, Bernhard
• Bartl, Johannes Daniel
• Finley, Jonathan J.
• Amati, Matteo
• Stutzmann, Martin
• Sharp, Ian
• Eichhorn, Johanna
• Gregoratti, Luca
• Christis, Maximilian
• Wolz, Lukas
• Zeller, Patrick
• Rauh, Felix

Abstract

Atomic layer deposition (ALD) is a key technique for the continued scaling of semiconductor devices, which increasingly relies on scalable processes for interface manipulation of structured surfaces on the atomic level. While ALD allows the synthesis of conformal films with utmost control over the thickness, atomically‐defined closed coatings and surface modifications are challenging to achieve because of 3D growth during nucleation. Here, a route is presented toward the sub‐nanometer thin and continuous aluminum oxide (AlOx) coatings on silicon substrates for the spatial control of the surface charge density and interface energetics. Trimethylaluminum in combination with remote hydrogen plasma is used instead of a gas‐phase oxidant for the transformation of silicon dioxide (SiO2) into alumina. Depending on the number of ALD cycles, the SiO2 can be partially or fully transformed, which is exploited to deposit ultrathin AlOx layers in selected regions defined by lithographic patterning. The resulting patterned surfaces are characterized by lateral AlOx/SiO2 interfaces possessing 0.3 nm step heights and surface potential steps exceeding 0.4 V. In addition, the introduction of fixed negative charges of 9 × 10^12 cm-2 enables modulation of the surface band bending, which is relevant to the field‐effect passivation of silicon and low‐impedance charge transfer across contact interfaces.

Topics

• density
• impedance spectroscopy
• surface
• phase
• aluminum oxide
• aluminium
• semiconductor
• Hydrogen
• Silicon
• atomic layer deposition