693.932 PEOPLE
| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Hausnerova, B.
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (12/12 displayed)
- 2011Rheological characterization of powder injection moulding using feedstock based on aluminium oxide and multicomponent water-soluble polymer binder
- 2010Wall-slip velocity as a quantitative measure of powder-binder separation during powder injection moulding
- 2008Rheological behavior of fibre-filled polymer melts at low shear rate Part II. Experimental investigation
- 2008Rheological behavior of fiber-filled polymer melts at low shear rate Part. I. Modeling of rheological properties
- 2006Rheology and fiber degradation during shear flow of carbon-fiber-reinforced polypropylenescitations
- 2006Pressure-dependent viscosity of powder injection moulding compoundscitations
- 2006Rheological properties of carbon fibre filled low-density polyethylene under the parallel steady and oscillatory shear flows
- 2005Relative viscosity models and their application to capillary flow data of highly filled hard-metal carbide powder compoundscitations
- 2005On PVT and rheological measurements of polymer melts: Correction of the hole fraction-viscosity relationshipcitations
- 2004Rheological behaviour of PP/PET and modified PP/PET blends. II. Dynamic viscoelastic properties
- 2003Rheological Behaviour of PP/PET and Modified PP/PET Blends. I. Steady State Flow Properties
- 2002Temperature dependent flow properties of powder injection moulding compounds
Places of action
| Organizations | Location | People |
|---|