| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Broniszewski, Kamil
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (11/11 displayed)
- 2015Al2O3-V cutting tools for machining hardened stainless steel
- 2015SILICON NITRIDE – MOLYBDENUM CUTTING TOOLS FOR CAST IRON MACHINING
- 2015Aging behaviour of AA6061/SiC<inf>p</inf> composites produced by direct extrusion with a reversibly rotating die methodcitations
- 2015Properties of alumina matrix composites reinforced with nickelcoated graphene
- 2015Influence of cooling condition on properties of extruded aluminum alloy matrix compositescitations
- 2015Al<inf>2</inf>O<inf>3</inf>–V cutting tools for machining hardened stainless steelcitations
- 2015Properties of Alumina Matrix Composites Reinforced with Nickel-coated Graphenecitations
- 2015Properties of alumina – graphene oxide compositescitations
- 2014Aging behaviour of AA6061/SiCp composites produced by direct extrusion with a reversibly rotating die method
- 2013Al2O3–Mo cutting tools for machining hardened stainless steelcitations
- 2013Al2O3-Ni composites for cutting tools
Places of action
| Organizations | Location | People |
|---|
article
Influence of cooling condition on properties of extruded aluminum alloy matrix composites
Abstract
This paper discusses the influence of applying water cooling after extrusion on the stability of mechanicalproperties on the AA6061-7.5 vol. % SiC composite rods cross section. The materials were prepared viapowder metallurgy processing using extrusion with a reversibly rotating die at the last technologicalstage. The mechanical properties, texture and microstructure of composites were analyzed following theexperiment. In both deformed samples the XRD measurements indicated that the <111> was the predominantorientation, which, however, was weaker towards the edge of the specimen. Moreover, somedifferences in microhardness between the center and the edge of water cooled rod were observed.